Buying guide

Pergola add-ons in Phoenix: screens, lighting, fans, heaters and misting

In Phoenix, motorized screens run $1,500–$4,000 per screen installed, integrated LED lighting $1,800–$4,200, two wired ceiling fans $1,400–$3,000, two infrared heaters $1,600–$3,800, and a high-pressure misting system built into the structure $2,800–$6,500. Everything wired needs an electrical permit, and misting tied to the house water needs a backflow preventer, so the cheapest time to add any of them is before the roof goes on.

Published · 5 min read · By Phoenix Louvered Pergolas

In the Phoenix metro: louvered pergolas from about $12,000, with a written quote before any work. Installation is done by a licensed Arizona contractor. Phoenix, Scottsdale, Mesa, Gilbert, Chandler, Tempe, Glendale, Peoria, Paradise Valley, Queen Creek. Call (602) 557-3625

Decide on add-ons before the roof goes on

Every add-on on this page either needs a wire or a water line through the structure. Running them while the posts and beams are open is routine; adding them later means exposed conduit or a second trade visit. Fenn Rogers, a Phoenix-area builder, makes the same point about misting lines: run them before the cover goes up. Ask for each add-on as a separate line on the quote, with its electrical or plumbing scope, so you can take or leave it without reopening the whole price.

Illustration of two installers setting an aluminum pergola post on a new concrete footing, checking it with a level.
Illustration: posts go on concrete footings, and crews let the concrete cure before building the frame.

Motorized retractable screens

Screens drop from a housing in the beam to close off a side of the pergola: insect mesh for evenings, solar mesh that blocks most of the heat and glare from a low sun, or privacy mesh. Roll-A-Shield, which manufactures them in Phoenix, says most local homeowners pay $1,500–$4,000 per screen installed, with solar-powered motors that need no electrician as an alternative to hardwired ones. National guides run higher: EDG Patio Shade puts one custom opening at $3,500–$8,000+ and a two- to four-opening patio at $8,000–$25,000+, and Go Retractable gives $3,000–$6,000 per opening.

FigurePublished rangeSource
Per screen installed, Phoenix$1,500–$4,000Roll-A-Shield
One custom opening$3,500–$8,000+EDG Patio Shade
Two to four openings$8,000–$25,000+EDG Patio Shade
Per opening, national$3,000–$6,000Go Retractable

Width and height set the price, then the mesh and the motor. On a louvered pergola the housings mount to the frame, so order the screens with the structure rather than after it.

Lighting, ceiling fans and heaters

Add-onPublished rangeSource
Integrated LED lighting, perimeter and downlights$1,800–$4,200AE Outdoor Living
Two outdoor ceiling fans wired through the structure$1,400–$3,000AE Outdoor Living
Two infrared electric heaters mounted in the structure$1,600–$3,800AE Outdoor Living

Fans do more than lights in a Phoenix summer: moving air under a closed louvered roof is the difference between a usable patio and a hot one. Heaters earn their place on winter evenings. Infrared electric heaters mount to a beam and need their own circuit; gas heaters need a gas line and permit of their own. All three run on the same electrical permit as the motor on a louvered roof, so bundling them into the original install saves a second permit later.

Misting systems

Misting is the Phoenix-specific add-on. Pressure is what matters: a garden-hose kit soaks furniture and barely cools, a mid-pressure system with its own pump makes a fine mist, and a high-pressure system at 1,000 PSI flash-evaporates for the most cooling with the least wetness. AE Outdoor Living prices a mid-pressure patio system with 12 to 20 nozzles at $1,500–$3,500 and a high-pressure one at $3,500–$5,500; built into a pergola or ramada, its cost guide gives $2,800–$6,500. Lone Star Landscaping, another Phoenix installer, says most patio misting installs run $4,000–$6,000.

FigurePublished rangeSource
Mid-pressure patio system, 12 to 20 nozzles$1,500–$3,500AE Outdoor Living
High-pressure patio system, 12 to 20 nozzles$3,500–$5,500AE Outdoor Living
High-pressure system built into the structure$2,800–$6,500AE Outdoor Living
Most patio installs, one installer$4,000–$6,000Lone Star Landscaping

Two rules apply. A system tied into the house’s drinking water needs a reduced-pressure backflow preventer, and in Arizona any job over $1,000 in parts and labor has to be done by a licensed contractor, so a high-pressure install is contractor work. Stainless lines are the usual choice in the Valley; copper is used when the lines are hidden inside the structure during construction.

Which add-ons need a permit

Add-onPermit
Motorized screens, hardwiredElectrical permit
Motorized screens, solar motorUsually none for the motor; check with the city
LED lighting, fans, electric heatersElectrical permit, shared with the louver motor
Gas heatersGas line permit
Misting tied to house waterBackflow preventer; permit rules vary by city

Running power to a structure needs a permit in every Valley city, even when the structure itself is exempt. The permit guide has each city’s rule, and the manual vs. motorized guide explains the circuit a louvered roof needs.

Which add-ons to choose

If you wantAdd
A cooler patio in JulyHigh-pressure misting and ceiling fans
Evenings without bugsInsect-mesh screens on the open sides
Less glare from a west-facing yardSolar-mesh screens, or louvers angled against the sun
Winter evenings outsideInfrared heaters and perimeter lighting
The lowest electrical scopeSolar-motor screens and a manual louvered roof

Sources

Prices are published figures, not quotes; checked September 29–30, 2026. Permit rules are paraphrased from each city’s own guidance, and they change, so the installer confirms them for your address.

Prices

Permit rules

Questions homeowners ask

How much do motorized pergola screens cost in Phoenix?

Roll-A-Shield, a Phoenix manufacturer, says most local homeowners pay $1,500–$4,000 per screen installed. National guides put one custom opening at $3,500–$8,000+.

Is a misting system worth it on a pergola in Phoenix?

For a patio you want to use in June through September, usually yes, if it is a mid- or high-pressure system: $1,500–$3,500 for mid-pressure and $3,500–$5,500 for high-pressure on a patio-sized run. Garden-hose kits wet furniture and barely cool.

Do fans and lights on a pergola need a permit?

Yes. Running power to a structure needs an electrical permit in every Valley city, and the fans, lights and louver motor usually share one circuit and one permit.

Can add-ons go on a patio cover as well as a pergola?

Yes. Screens, lighting, fans, heaters and misting lines mount to an aluminum patio cover or a ramada the same way; the difference is that a solid roof already blocks the sun, so misting and fans matter more than screens.

More answers in the pergola and patio cover FAQ, or see how a request works.

Get a written quote

Leave your name and number. A licensed installer calls you back, visits to measure, and quotes the job in writing before any work starts.

Call (602) 557-3625

Installation is done by a licensed Arizona contractor.